These solid brass, handmade figure-8 bell pins are used to fasten shank-style bells onto a leather strap.
These pins are easier to install and are more historically accurate than machine-made bell pins available from other sources. Click "Enlarge" to see how to fasten a bell onto a leather strap with a bell pin.
Please note that our handmade bell pins may require an extra day or two to ship, since we make them as needed. The size and shape of each pin will vary slightly due to its handmade nature.
Small pins: For small bells with short "U" shanks or drilled-hole shanks. If you put the shank of the bell through your leather strap and can see only part of the hole in the bell's shank, you should use these pins. These pins are made of lightweight wire. Tip: If you cannot see any of the hole at all, you should think seriously about using a thinner strap.
Medium pins: For small to medium bells or for straps up to 1 1/8" wide. If you put the shank of the bell through your leather strap and can easily see daylight through the hole in the bell's shank, use these pins. These pins are made of our standard bell-pin wire.
Large pins: For medium to large bells, especially if the strap is 1 1/8" wide or wider. These pins are made from the same wire as our medium pins, but the overall shape is longer and broader to better support larger, heavier bells. Tip: If the shank of the bell is especially large, which is often the case with early 1800s bells, the bell will be very loose on the strap. You can fasten two of these pins through the shank to tighten the fit.
Sold per each.