CPOP after saponification

Help! My CP soap did not gel and I wanted it to gel. The soap is staying too soft with a powdery or clay like texture even though it is fully saponified.

What's a frustrated soaper to do? Soft soap like this will eventually firm up on its own, but the process can take days or even weeks and that can be frustrating. If gently heated, however, this too-soft, not-gelled soap will become firm within an hour or two. The soap will also have the translucent look of soap that has gone through gel during saponification.

A possible secondary benefit of this "CPOP after the fact" method is that it may help to soften the bullseye ring of a partial gel. I cannot guarantee the bullseye look will disappear, but some soapers who have tried this think the ring becomes a little less obvious.

I take no credit for being the inventor of this idea; I'm just sharing it with other soapers.

Here is the method I use --

Preheat your oven to the lowest temperature possible -- usually somewhere between 145-170 F (62-70 C).

Put the soap back in its mold. It makes no difference if the soap has been cut or not.

If the mold you used is not oven safe, not available, or not convenient to reuse, put the soap on a parchment lined cookie sheet or some container that is oven safe and fresh soap safe.

Put the soap into the preheated oven. Let the soap warm for 1 hour or so, and then check the texture and visual appearance. It should look slightly more translucent and should feel firmer.

If you do not think the soap is quite ready, let it warm another 1/2 hour or so. I have not seen any benefits to heating the soap more than 1 to 1 1/2 hours.

The soap will not get soft nor will it look like it is in gel. In my experience, cut bars or rough peaked tops will stay fine.

If you can spare the oven, turn it off at that point and leave the soap in the oven to cool down. Otherwise, take the soap out, cover with a towel and let it cool slowly.